System crashes due to overheating

I’m not sure that sharing this will be terribly helpful for me to post, but I wanted to thank you for including the sensors output. If you’re concerned about overheating, I just wanted to chime in and say that I’ve made some (aggressive) modifications to my FW 16, and it appears to be able to sustain 80W draw on the CPU with burst peaks going just over 100W. My temps stay around 85c during this, and my fan speed averages 4000 rpm (4100 and 3900).

I don’t know what your CPU power draw/load is during the sensors grab you shared, but my fan speed is already 15% lower than that when at 100% load @ 80W+ draw. My unit is a batch 1 motherboard that shipped with the overheating issue, so I imagine if it’s possible on my board it’s possible on others as well.

Note: there’s not really much of a performance gain by unlocking the power target that far. It’s just fun.

If you’re interested in what those mods are, I’ve listed them here:
https://community.frame.work/t/rx-7700s-dgpu-vent-covers-v3-now-with-bottom-riser

All the modifications I’ve made to my FW 16 (so far) - Framework Laptop 16 - Framework Community