Have there been any updates lately to the screen’s aluminum cover to make it less prone to screen flex? When was the last update? I assume the same aluminum is used for both regular and high-resolution screens.
Which machine? I have a FW 13 and a 16 and haven’t had any issues with the screen/aluminum top cover on either of them. In fairness, I’m pretty careful with both of them, though the 13 has gotten used a lot, and it has been knocked around a bit.
2 Likes
To my knowledge, if it’s regarding the FL13, there’s only been one update from non-CNC to a CNC lid…to make the centre (logo area) dip / dish less when pressed. However, does that also make it flexes less? I’m not sure.
Some mechanical designs would suggest that some amount of flex / compliance is a good thing.