Can I use corner guards for framework 13

[MJ1]

Sadly I don’t see 3d models for the laptop shell on Framework’s github Repositories · GitHub
If you do design corner guards, it would be nice if you share the files, I’m sure there are others that would be interested.

Found this thread about a hardshell or corner guards. Hard shell | case for framework laptop wanted

@RootInit

I was considering 3d printing corner reinforcements for the lid and base. I’m not particularly good at parametric design though. Really need official shell 3d model to boolean off of. Plan was essentially to attach them with 3m foam inside recessed grooves. Not sure if a stiff TPU would be best or perhaps just single wall PLA which would crumple and absorb impact. Even if fully ridged it would spread out impacts I think.

Would those be the same type of corner guards you’re talking about?