Thanks for making this! Just printed on a Bambu H2C with translucent PETG, and I’m shocked at how great it turned out (no offense intended, it’s just a very complicated model).
Actually was able to mostly get the input cover on, with both bottom screws connecting perfectly. The back near the power button/hinge is where things get a little wonky. Can’t fit in the fingerprint module, and the center rear screw hole would require a comically long screw (plus I just think there’s too much material to fit right).
Overall a FANTASTIC start–I love this community, and if I get some time before my wedding might try to remix your model to help out (although I’m not optimistic I’ll have time).
