I was wondering the same thing. The possibility to use ECC RAM would be a Unique Selling Point. Would instantly buy three of those boards if this is true.
8 Likes
Really like the presentation for the 16.
I want ECC for main system memory and ECC for the 16” GPU. !!!
3 Likes
I am also very interested in knowing the answer to this. I posted a separate thread asking about ECC RAM for the Framework Laptop 16 ( ECC support? ) but that is currently under information embargo.
That said, I’m curious to know about what the verdict is for the Framework Laptop 13 as well.
According to the full specification of both Ryzen 7640U and Ryzen 7840U, ECC is supported by the U-series APUs found on the new motherboards, too:
https://www.amd.com/en/product/13186
https://www.amd.com/en/product/13196
So, it’s down to Framework themselves whether ECC will work.
10 Likes
DDR5 modules have on-die ECC support. Full ECC support is not currently confirmed as compatible with non-PRO Ryzen 7040 Series mobile processors.
Edit: nrp’s comment: ECC support? - #86 by nrp
1 Like
That’s a pretty uninspiring statement from them. That is always what AMD says, and they always support ECC on the right board with it enabled in firmware. It’s the same memory controller, after all. It’s just not guaranteed by the spec so they could in theory change it in a later silicon revision, though they won’t because designing a new memory controller isn’t worth it.
See e.g. https://www.hwcooling.net/en/amd-launches-ryzen-7040-4nm-apu-with-zen-4-cores-and-rdna-3-en/ for reporting that confirms this.
If Framework claims they didn’t get it working in a small test, then why does it say in the official AMD specification that ECC memory is supported by non-Pro models?
TBF, even the AM5 socket, which also advertised ECC support, took a while for the BIOS support to enable it. It’s dependent on the CPU, wiring, BIOS, AGESA, and finally the OS. It wasn’t until recently that AMD added ECC support and until version 6.5 of the Linux Kernel (released a few weeks ago). There are entire threads with crowdsourced posts following the slow confirmation of which motherboards and BIOS combinations support ECC.
3 Likes
Relevant: [RESPONDED] AMD Batch 1 Guild - #196 by TheTwistgibber
Edit: Personally, I’ll experiment with an ECC RAM kit because I can unless someone else does that before me.
4 Likes
The spec sites for 7640U and 7640U PRO do not differ at all with regard to ECC support. Both say: “Yes (FP7r2 only; Requires platform support)”.
I’m in the same boat as @resample and would risk buying ECC SO-DIMMS just to experiment with this since I would love ECC in my AMD Batch 1 FW 13. The only reason for me to not even try would be a definitive statement with hardware based reasons (other than “it’s the non-pro processor”) for ECC not being able to work, e.g. missing traces on the mainboard.
My desktop is an AM4 board with 3700X bought very close to release and the ECC support needed some UEFI/AGESA updates and patches to the linux kernel to actually work including error reporting. That took several months to come together but since then works perfectly. So if the hardware is at least theoretically capable I will try this. Probably with two of Kingston’s KSM56T46BS8KM-16HA. 5600MT JEDEC and ECC.
4 Likes
According to the last blog post the first AMD Frameworks will soon be on their way. Time to buy some memory 
Has anyone found some 5600MT ECC DDR5 other than KSM56T46BS8KM-16HA?
2 Likes
Short update: The memory itself works fine without parity. dmidecode -t memory shows 72 bit total width, that would be 64 bit data plus 8 bit parity. This alone does not mean anything in regards to potential for actually working ECC. It’s however at least better than dmidecode showing only the 64 data bits for total width. All other sources (edac-util, ras-mc-ctl, kernel boot log) I tried do not show anything that hints to working ECC.
6 Likes
Does this mean that the motherboard wiring has added ECC traces ?
No. This is read out from ID chips on the RAM.
2 Likes
No changes with BIOS 3.03 but I did not really expect any.
The modules delivered by framework are reported as 64 bit wide, and so the physical memory array description concludes: “Error Correction Type: None”. Does it say something else with your 72 bit modules?
# dmidecode 3.5
Getting SMBIOS data from sysfs.
SMBIOS 3.5.0 present.
Handle 0x0011, DMI type 16, 23 bytes
Physical Memory Array
Location: System Board Or Motherboard
Use: System Memory
Error Correction Type: None
Maximum Capacity: 64 GB
Error Information Handle: 0x0014
Number Of Devices: 2
Handle 0x0012, DMI type 17, 92 bytes
Memory Device
Array Handle: 0x0011
Error Information Handle: 0x0015
Total Width: 64 bits
Data Width: 64 bits
Size: 16 GB
Form Factor: SODIMM
Set: None
Locator: DIMM 0
Bank Locator: P0 CHANNEL A
Type: DDR5
Type Detail: Synchronous Unbuffered (Unregistered)
Speed: 5600 MT/s
Manufacturer: A-DATA Technology
Serial Number: 00013173
Asset Tag: Not Specified
Part Number: AD5S560016G-B
Rank: 1
Configured Memory Speed: 5600 MT/s
Minimum Voltage: 1.1 V
Maximum Voltage: 1.1 V
Configured Voltage: 1.1 V
Memory Technology: DRAM
Memory Operating Mode Capability: Volatile memory
Firmware Version: Unknown
Module Manufacturer ID: Bank 5, Hex 0xCB
Module Product ID: Unknown
Memory Subsystem Controller Manufacturer ID: Unknown
Memory Subsystem Controller Product ID: Unknown
Non-Volatile Size: None
Volatile Size: 16 GB
Cache Size: None
Logical Size: None
Handle 0x0013, DMI type 17, 92 bytes
Memory Device
Array Handle: 0x0011
Error Information Handle: 0x0016
Total Width: 64 bits
Data Width: 64 bits
Size: 16 GB
Form Factor: SODIMM
Set: None
Locator: DIMM 0
Bank Locator: P0 CHANNEL B
Type: DDR5
Type Detail: Synchronous Unbuffered (Unregistered)
Speed: 5600 MT/s
Manufacturer: A-DATA Technology
Serial Number: 00236745
Asset Tag: Not Specified
Part Number: AD5S560016G-B
Rank: 1
Configured Memory Speed: 5600 MT/s
Minimum Voltage: 1.1 V
Maximum Voltage: 1.1 V
Configured Voltage: 1.1 V
Memory Technology: DRAM
Memory Operating Mode Capability: Volatile memory
Firmware Version: Unknown
Module Manufacturer ID: Bank 5, Hex 0xCB
Module Product ID: Unknown
Memory Subsystem Controller Manufacturer ID: Unknown
Memory Subsystem Controller Product ID: Unknown
Non-Volatile Size: None
Volatile Size: 16 GB
Cache Size: None
Logical Size: None
It says Error Correction Type: None for me too. That is the same as my Zen 2 desktop if I disable ECC in the BIOS there. With ECC enabled my desktop shows Error Correction Type: Multi-bit ECC.
Sounds like you’re trying to test ECC in the new AMD frame.work? I heard a mere firmware update could be the difference between the motherboard supporting it or not… Hope might not be lost afterall! Unsure if that includes the APU, but it would be sweet if the integrated graphics could use ECC too!