The screws are honestly fine. Just make sure to not tighten them too much, just go until you feel the slightest resistance.
You don’t need to add downforce with torx, that’s mostly a thing with crosshead screws.
But I also found that the Framework screwdriver tip was very bad. It was slightly too small, not creating a good grip, and way too soft, stripping easily with the slightest resistance. Had no problems when using a proper Wera driver.
I know making such a tiny bit is hard, and I know the Framework screwdriver is relatively cheap, at just $7 on the marketplace, but compared to a proper screwdriver, the Framework one feels like it’s made out of chinesium.
