I’m really confused by how an input current of 5,000 is working for you, unless you’re using a lower wattage charger for the FW 13. The default value for me on my FW 16’s 240W charger is over 10,000 (I see now that I didn’t share any of those default values earlier). As far as I understand, it pulls about 4.5A at ~47V, but as far as I can tell this ectool only see’s the current after it’s been stepped down to 17.6V, which would be need a much higher amperage for the same watt load. This higher value is closer to what I see in the default value (i.e. >5000). When I did the 5000 as you suggested while gaming, my system started to freak out as if it couldn’t figure out whether it should be using the charger or using the battery.
On your charger, what is the default chg_input_current before you modify it?