DIY portable monitor enclosure using amazon parts

I managed to make my own enclosure, using off the shelf parts from amazon. it uses DisplayPort and requires usbc power.
Total cost 30$ not including double sided tape and electrical tape.

8.5x12 inch picture frame
Amazon.com - JCJMY 8.5x12 Picture Frame Gold for Wall Hanging or Tabletop, Wall Mounting Horizontally or Vertically, 8.5 x 12 Wall Gallery Poster Photo Frame with Shatter Resistant Plexiglass, Gold

controller board which is compatible with the matte 60hz and the non touch 2.8k display
Amazon.com: Beuiouer DP to EDP 4K 120HZ DIY4K Driver Board 4K 2K 1080 Adapter Board for Portable Display(A) Easy Install : Electronics

40 pin to 40 pin cable
Amazon.com: VSDISPLAY 40Pin Signal Cable for eDP LCD Screen,Fit for 4K Panel : Electronics

You do have to remove the retaining clips from the display for it to fit in the picture frame.

13 Likes

ordered the parts! looking forward to reusing my old display. thanks for sharing!

No problem, I used electrical tape so the panel wouldn’t shift inside the frame and double-sided tape to hold the controller board to the back. I recommend cutting a small slot where the cable goes in from the back so there’s less stress on the 40 pin cable.

1 Like

I love the use of a picture frame as a monitor chassis.